0.5 Ω , Quad SPDT Switches in UCSP/QFNELECTRICAL CHARACTERISTICS (continued) (V+ = +2.7V to +5.25V, TA = -40°C to +85°C, unless otherwise noted. Typical values are at +3V and TA = +25°C.) (Notes 2, 3) PARAMETERSYMBOLCONDITIONSTAMINTYPMAXUNITS Total Harmonic f = 20Hz to 20kHz, 1V THD P-P, +25°C 0.035 % Distortion RL = 32Ω, VDC = V+/2 NO_, NC_ Off- CNO_(OFF), VNO, VNC_ = GND, +25°C 180 pF Capacitance CNC_(OFF) f = 1MHz (Figure 5) COM_ Off-Capacitance CCOM_(OFF) V C OM _ = G N D , f = 1M H z ( Fi g ur e 5) +25°C 300 pF COM_ On-Capacitance C(ON) VCOM_ = GND, f = 1MHz (Figure 5) +25°C 400 pF DIGITAL I/O (IN_, EN ) V+ = 2.7V to 3.6V, TMIN to 1.4 MAX4754/MAX4755/MAX4756 TMAX V+ = 2.7V to 5.25V, TMIN to Input Logic-High VIH 1.4 V MAX4754A/MAX4756A TMAX V+ = 3.6V to 5.25V, TMIN to 2.0 MAX4754/MAX4755/MAX4756 TMAX V+ = 2.7V to 3.6V, TMIN to 0.5 MAX4754/MAX4755/MAX4756 TMAX V+ = 2.7V to 5.25V, TMIN to Input Logic-Low VIL 0.5 V MAX4754A/MAX4756A TMAX V+ = 3.6V to 5.25V, TMIN to 0.6 MAX4754/MAX4755/MAX4756 TMAX T Input Leakage Current I MIN to IN VIN = 0V or V+ 1 µA TMAX POWER SUPPLY T Power-Supply Range V+ MIN to 1.8 5.5 V TMAX +25°C 0.2 V+ = 5.5V, VIN_ = 0V or V+, MAX4754/MAX4754A/MAX4755/MAX4756/ TMIN to µA 2 MAX4756A TMAX Power-Supply Current I+ +25°C 6.5 V+ = 5.5V, VIN_ = 0.5V or 1.4V, T µA MAX4754A/MAX4756A MIN to 12 TMAX Note 2: The algebraic convention is used in this data sheet; the most negative value is shown in the minimum column. Note 3: UCSP parts are 100% tested at +25°C and limits across the full temperature range are guaranteed by correlation and design. TQFN parts are 100% tested at +85°C and limits across the full temperature range are guaranteed by correlation and design. Note 4: RON and ΔRON matching specifications are guaranteed by design and correlation. Note 5: ΔRON = RON(MAX) - RON(MIN). Note 6: Flatness is defined as the difference between the maximum and minimum value of on-resistance as measured over the specified analog signal ranges. MAX4754/MAX4754A/MAX4755/MAX4756/MAX4756ANote 7: Guaranteed by design, not production tested. Note 8: Off-Isolation = 20log10 [VCOM / (VNO or VNC)], VCOM = output, VNO or VNC = input to off switch. Note 9: Between any two switches. 4_______________________________________________________________________________________