Datasheet TLP2363 (Toshiba) - 3

FabricanteToshiba
DescripciónPhotocouplers Infrared LED & Photo IC
Páginas / Página18 / 3 — TLP2363. 7. Absolute. Maximum. Ratings. (Note). (Unless. otherwise. …
Formato / tamaño de archivoPDF / 856 Kb
Idioma del documentoInglés

TLP2363. 7. Absolute. Maximum. Ratings. (Note). (Unless. otherwise. specified,. Ta. =. 25. ). Characteristics. Symbol. Note. Rating. Unit. LED. Input. forward

TLP2363 7 Absolute Maximum Ratings (Note) (Unless otherwise specified, Ta = 25 ) Characteristics Symbol Note Rating Unit LED Input forward

Línea de modelo para esta hoja de datos

Versión de texto del documento

TLP2363 7. Absolute Maximum Ratings (Note) (Unless otherwise specified, Ta = 25 ) Characteristics Symbol Note Rating Unit LED Input forward current IF 25 mA Input forward current derating (Ta ≥ 85 ) ∆IF/∆Ta -0.5 mA/ Input forward current (pulsed) IFP (Note 1) 50 mA Input forward current derating (pulsed) (Ta ≥ 85 ) ∆IFP/∆Ta -1.0 mA/ Peak transient input forward current IFPT (Note 2) 1 A Peak transient input forward current (Ta ≥ 85 ) ∆IFPT/∆Ta -20 mA/ derating Input power dissipation PD 40 mW Input power dissipation derating (Ta ≥ 85 ) ∆PD/∆Ta -0.8 mW/ Input reverse voltage VR 5 V Detector Output current IO 25 mA Output voltage VO -0.5 to 6 V Supply voltage VCC -0.5 to 6 V Output power dissipation PO 60 mW Output power dissipation derating (Ta ≥ 85 ) ∆PO/∆Ta -1.2 mW/ Common Operating temperature Topr -40 to 105 Storage temperature Tstg -55 to 125 Lead soldering temperature (10 s) Tsol 260 Isolation voltage (AC, 60 s, R.H. ≤ 60 %) BVS (Note 3) 3750 Vrms Note: Using continuously under heavy loads (e.g. the application of high temperature/current/voltage and the significant change in temperature, etc.) may cause this product to decrease in the reliability significantly even if the operating conditions (i.e. operating temperature/current/voltage, etc.) are within the absolute maximum ratings. Please design the appropriate reliability upon reviewing the Toshiba Semiconductor Reliability Handbook ("Handling Precautions"/"Derating Concept and Methods") and individual reliability data (i.e. reliability test report and estimated failure rate, etc). Note: A ceramic capacitor (0.1 µF) should be connected between pin 6 and pin 4 to stabilize the operation of a high- gain linear amplifier. Otherwise, this photocoupler may not switch properly. The bypass capacitor should be placed within 1 cm of each pin. Note 1: Pulse width (PW) ≤ 1 ms, duty = 50 % Note 2: Pulse width (PW) ≤ 1 µs, 300 pps Note 3: This device is considered as a two-terminal device: Pins 1 and 3 are shorted together, and pins 4, 5 and 6 are shorted together. ©2019 3 2019-11-07 Toshiba Electronic Devices & Storage Corporation Rev.1.0