Preliminary Datasheet P9415 (IDT) - 8

P9415 Preliminary Datasheet Electrical Characteristics Table VRECT = 5.5 V1, CLDO1P8_OUT = CLDO5P0_OUT = 2.2 μF, CMLDO_VOUT = 10 μF, nEN = 0 V, unless otherwise noted. TJ =-5C to 125C, Typical values are at 25°C.
Table 4. Device Characteristics (Continued) Symbol Description Conditions Min Typ Max Units Enable Input nEN
VIH Input Threshold High 1.5 V VIL Input Threshold Low 0.25 V InEN_LKG nEN Leakage Current VnEN = 0 V ± 1 μA VnEN = 5.0 V 2.5 μA
Open Drain Inputs/Outputs (SCL, SD, OD2, OD3, OD4)
VIH Input High Voltage 1.4 V VIL Input Low Voltage 0.5 V V = 0 V and 1.8 V; Digital or ADC I LKG Input Leakage Current ± 1 μA input mode. VOL Output Low Voltage IOL = 8 mA 0.36 V
Push-Pull General Purpose Inputs/Outputs (GP0, GP1, GP2, GP3, GP4, GP5, GP6)
VIH Input High Voltage 1.4 V VIL Input Low Voltage 0.5 V V = 0 V and 1.8 V; Digital or ADC I LKG Input Leakage Current ± 1 μA input mode. I V OH = 8 mA (for all combined OH Output High Voltage 1.44 V GPIOs) I V OL = 8 mA (for all combined OL Output Low Voltage 0.36 V GPIOs)
ECLAMP_DRV Output
VOH Output High Voltage IOH = 8 mA 4.9 V VOL Output Low Voltage IOL = 8 mA 0.36 V
SCL, SDA (I2C Interfaces SCL (OD0), SDA (OD1)
fSCL Clock Frequency 400 kHz Hold Time (Repeated) for tHD,STA 0.6 µs START Condition tHD:DAT Data Hold Time 0 ns tLOW Clock Low Period 1.3 µs tHIGH Clock High Period 0.6 µs Set-up Time for Repeated tSU:STA 0.6 µs START Condition Bus Free Time Between tBUF STOP and START 1.3 µs Condition CB Capacitive Load for Each 150 pF Bus Line CI SCL, SDA Input 5 pF © 2019 IDT  A Renesas Company. 8 Revision 0.8 August 29, 2019