LT8410/LT8410-1 Ultralow Power Boost Converter with Output Disconnect FEATURESDESCRIPTION n Ultralow Quiescent Current The LT®8410/LT8410-1 are ultralow power boost converters 8.5μA in Active Mode with integrated power switch, Schottky diode and output 0μA in Shutdown Mode disconnect circuitry. The parts control power delivery by n Comparator Built into SHDN Pin varying both the peak inductor current and switch off- n Low Noise Control Scheme time. This control scheme results in low output voltage n Adjustable FB Reference Voltage ripple as well as high efficiency over a wide load range. n Wide Input Range: 2.5V to 16V The quiescent current is a low 8.5μA, which is further n Wide Output Range: Up to 40V reduced to 0μA in shutdown. The internal disconnect n Integrated Power NPN Switch circuitry allows the output voltage to be blocked from the 25mA Current Limit (LT8410) input during shutdown. High value (12.4M/0.4M) resis- 8mA Current Limit (LT8410-1) tors are integrated on chip for output voltage detection, n Integrated Schottky Diode significantly reducing input referred quiescent current. The n Integrated Output Disconnect LT8410/ LT8410-1 also features a comparator built into the n High Value (12.4M/0.4M) Feedback Resistors SHDN pin, overvoltage protection for the CAP and VOUT Integrated pins, built in soft-start and comes in a tiny 8-pin 2mm × n Built in Soft-Start (Optional Capacitor from VREF 2mm DFN package. to GND) L, LT, LTC, LTM, Linear Technology and the Linear logo are registered trademarks of Linear n Overvoltage Protection for CAP and V Technology Corporation. All other trademarks are the property of their respective owners. OUT Pins Protected by U.S. Patents, including 5481178, 6580258, 6304066, 6127815, 6498466, n Tiny 8-Pin 2mm × 2mm DFN Package 6611131. APPLICATIONS n Sensor Power n RF Mems Relay Power n General Purpose Bias TYPICAL APPLICATIONOutput Voltage RippleGeneral Purpose Bias with Wide Input Voltagevs Load CurrentEfficiency vs Load Current V 10 100 IN 100µH 2.5V to 16V VIN = 3.6V VIN = 12V 90 2.2µF 0.1µF 8 SW CAP V V IN = 5V OUT = 16V 80 VCC VOUT 6 V LT8410 IN = 3.6V 0.1µF* CHIP V 70 REF ENABLE SHDN 4 604k EFFICIENCY (%) 60 GND FBP 0.1µF PEAK-TO-PEAK RIPPLE (mV) 2 412k V OUT 50 *HIGHER VALUE CAPACITOR IS REQUIRED WHEN THE V 8410-1 TA01a IN IS HIGHER THAN 5V 0 40 0.01 0.1 1 10 0.01 0.1 1 10 100 LOAD CURRENT (mA) 8410-1 TA02 LOAD CURRENT (mA) 8410-1 TA03 84101fc For more information www.linear.com/LT8410 1 Document Outline Description Applications Description Typical Application Absolute Maximum Ratings Pin Configuration Order Information Electrical Characteristics Typical Performance Characteristics Features Pin Functions Block Diagram Operation Applications Information Typical Applications Package Description Revision History Typical Application Related Parts