Datasheet Analog Devices RH1016MW — Ficha de datos

RH1016M
UltraFast Precision
10ns Comparator
DESCRIPTION ABSOLUTE MAXIMUM RATINGS The RH1016 is an UltraFastTM 10ns comparator that interfaces directly to TTL/CMOS logic while operating from
either ±5V or single 5V supplies. Tight offset voltage
specifications and high gain allow the RH1016 to be used
in precision applications. Matched complementary outputs
further extend the versatility of this comparator. Positive Supply Voltage (Note 5).7V
Negative Supply Voltage .–7V
Differential Input Voltage (Note 7).±5V
+IN, –IN and LATCH ENABLE Current (Note 7) .±10mA
Output Current (Continuous) (Note 7) .±20mA
Operating Temperature Range. –55°C to 125°C
Storage Temperature Range. –65°C to 150°C
Lead Temperature (Soldering, 10 sec) . 300°C (Note 1) A unique output stage provides active drive in both directions for maximum speed into TTL/CMOS logic or passive
loads, yet does not exhibit the large current spikes found
in conventional output stages. This allows the RH1016 to
remain stable with the outputs in the active region which
greatly reduces the problem of output “glitching” when
the input signal is slow moving or is low level. L, LT, LTC and LTM are registered trademarks of Linear Technology Corporation.
UltraFast is a trademark of Linear Technology Corporation.
All other trademarks are the property of their respective owners. The RH1016 has a LATCH pin which will retain input data
at the outputs, when held high. Quiescent negative power …