Datasheet TDK TPLC553030 — Ficha de datos

I N D U C T O R S
March 2018 Transponder coils TPLC series
TPLC553030 (2/7) I N D U C T O R S REMINDERS FOR USING THESE PRODUCTS
Before using these products, be sure to request the delivery specifications. SAFETY REMINDERS
Please pay sufficient attention to the warnings for safe designing when using these products. REMINDERS
The storage period is less than 12 months. Be sure to follow the storage conditions (Temperature: 5 to 40В°C, Humidity: 10 to 75% RH
or less).
If the storage period elapses, the soldering of the terminal electrodes may deteriorate.
Do not use or store in locations where there are conditions such as gas corrosion (salt, acid, alkali, etc.).
Before soldering, be sure to preheat components.
The preheating temperature should be set so that the temperature difference between the solder temperature and chip temperature
does not exceed 150В°C.
Soldering corrections after mounting should be within the range of the conditions determined in the specifications.
If overheated, a short circuit, performance deterioration, or lifespan shortening may occur.
When embedding a printed circuit board where a chip is mounted to a set, be sure that residual stress is not given to the chip due to
the overall distortion of the printed circuit board and partial distortion such as at screw tightening portions.
Self heating (temperature increase) occurs when the power is turned ON, so the tolerance should be sufficient for the set thermal
design.
Use a wrist band to discharge static electricity in your body through the grounding wire.
Do not expose the products to magnets or magnetic fields.
Do not use for a purpose outside of the contents regulated in the delivery specifications.
If an ultrasonic process is used, thoroughly check the condition setting in order to prevent disconnection.
Do not clean the products with solvents. If a potting resin or a moisture-proof coat containing a solvent such as acetone, toluene or …