Datasheet Microchip MCP2562FD-E/SN — Ficha de datos

MCP2561/2FD
High-Speed CAN Flexible Data Rate Transceiver
Features: Description: Optimized for CAN FD (Flexible Data rate) at 2, 5
and 8 Mbps Operation
-Maximum Propagation Delay: 120 ns
-Loop Delay Symmetry: -10%/+10% (2 Mbps) Implements ISO-11898-2 and ISO-11898-5
Standard Physical Layer Requirements Very Low Standby Current (5 ВµA, typical) VIO Supply Pin to Interface Directly to пЂ 
CAN Controllers and Microcontrollers with пЂ 
1.8V to 5.5V I/O SPLIT Output Pin to Stabilize Common Mode in
Biased Split Termination Schemes CAN Bus Pins are Disconnected when Device is
Unpowered
-An Unpowered Node or Brown-Out Event will
Not Load the CAN Bus Detection of Ground Fault:
-Permanent Dominant Detection on TXD
-Permanent Dominant Detection on Bus Power-on Reset and Voltage Brown-Out
Protection on VDD Pin Protection Against Damage Due to Short-Circuit
Conditions (Positive or Negative Battery Voltage) Protection Against High-Voltage Transients in
Automotive Environments Automatic Thermal Shutdown Protection Suitable for 12V and 24V Systems Meets or exceeds stringent automotive design
requirements including “Hardware Requirements
for LIN, CAN and FlexRay Interfaces in
Automotive Applications”, Version 1.3, May 2012
-Radiated emissions @ 2 Mbps with Common
Mode Choke (CMC) …