Datasheet Intersil EL7154CS-T7 — Ficha de datos

DATASHEET
EL7154 FN7278
Rev 4.00
November 23, 2015 High Speed, Monolithic Pin Driver
The EL7154 three-state pin driver is particularly well suited
for ATE and level shifting applications. The 4A peak drive
capability, makes the EL7154 an excellent choice when
driving high speed capacitive lines. Features The P-Channel MOSFET is completely isolated from the
power supply, providing a high degree of flexibility. Pin (7)
can be grounded, and the output can be taken from pin (8)
when a “source follower” output is desired. The N-Channel
MOSFET has an isolated drain, but shares a common bus
with pre-drivers and level shifter circuits. This is necessary to
ensure that the N-Channel device can turn off effectively
when VL goes below GND. In some power-FET and IGBT
applications, negative drive is desirable to insure effective
turn-off. The EL7154 can be used in these applications by
returning VL to a moderate negative potential. 3V and 5V Input compatible Comparatively low cost Three-State output Clocking speeds up to 10MHz 20ns Switching/delay time 4A Peak drive Isolated drains Low output impedance: 2.5пЃ— Low quiescent current: 5mA Wide operating voltage: 4.5V to16V Isolated P-Channel device Pinout Separate ground and VL pins EL7154
(8 LD PDIP, 8 LD SOIC)
TOP VIEW Pb-free available (RoHS compliant) Applications
VDD
1 VH Loaded circuit board testers 8 Digital testers Level shifting below GND THREE-STATE
2 LEVEL …