Datasheet Intersil X9C104PM — Ficha de datos

DATASHEET
X9C102, X9C103, X9C104, X9C503 FN8222
Rev 3.00
July 20, 2009 Digitally Controlled Potentiometer (XDCPв„ў)
The X9C102, X9C103, X9C104, X9C503 are Intersils’
digitally controlled (XDCP) potentiometers. The device
consists of a resistor array, wiper switches, a control section,
and non-volatile memory. The wiper position is controlled by
a three-wire interface.
The potentiometer is implemented by a resistor array
composed of 99 resistive elements and a wiper switching
network. Between each element and at either end are tap
points accessible to the wiper terminal. The position of the
wiper element is controlled by the CS, U/D, and INC inputs.
The position of the wiper can be stored in non-volatile
memory and then be recalled upon a subsequent power-up
operation. Features Solid-State Potentiometer Three-Wire Serial Interface 100 Wiper Tap Points
-Wiper Position Stored in Non-volatile Memory and
Recalled on Power-up 99 Resistive Elements
-Temperature Compensated
-End-to-End Resistance, В±20%
-Terminal Voltages, В±5V The device can be used as a three-terminal potentiometer or
as a two-terminal variable resistor in a wide variety of …