Datasheet Texas Instruments UCC28C45DG4 — Ficha de datos

Fabricante	Texas Instruments
Serie	UCC28C45
Numero de parte	UCC28C45DG4

Hojas de datos

Precios

Estado

Embalaje

Paramétricos

Plan ecológico

Notas de aplicación

• Descargar
  UCC38C44 12-V Isolated Bias Supply (Rev. A)
  PDF, 324 Kb, Revisión: A, Archivo publicado: oct 9, 2008
  This reference design describes a discontinuous, peak current-mode flyback converter whose input voltage is generated from the output of a universal power factor correction circuit. The converter is designed to operate at a switching frequency of 225 kHz, requires minimal parts, and supports an isolated 12-V, 3-W output and a non-isolated 12-V, 1-W output ideally suited for chip bias and voltage f
• Descargar
  UCC38C42 25-W Forward Converter
  PDF, 320 Kb, Archivo publicado: sept 6, 2002
  This reference design presents a self-resonant reset forward converter using the UCC38C42 BiCMOS Low-Power Current-Mode PWM Controller. The input voltage for this converter is compatible with the telecom input voltage range of 36 VDC to 72 VDC. The converter is designed to operate at a switching frequency of 525 kHz, requires minimal parts, and supports an isolated 2.5-V 10-A output. The complete
• Descargar
  UCC38C42 Family of High-Speed BiCMOS Current-Mode PWM Controllers
  PDF, 280 Kb, Archivo publicado: feb 7, 2002
  Since their introduction in the mid 1980?s the bipolar UC3842 family of Pulse width modulation (PWM)controllers has grown to become the most widely-used control strategy in the power supply industry. [1] The reasons for success are quite clear the devices feature an elegantly simple yet very effective control architecture they use only 8 pins they can drive MOSFET gates directly and they offer
• Descargar
  U-111 Practical Considerations in Current Mode Power Supplies
  PDF, 787 Kb, Archivo publicado: sept 5, 1999
  This application note explains the numerous PWM functions and ways to maximize their usefulness. It covers practical circuit design considerations such as slope compensation gate drive circuitry external control functions synchronization and paralleling current-mode controlled modules. Circuit diagrams and simplified equations are included.
• Descargar
  DN-42A Design Considerations for Transitioning from UC3842 to the New UCC3802
  PDF, 42 Kb, Archivo publicado: sept 5, 1999
  The UCC3802 offers numerous advantages that allow the power supply design engineer to meet requirements for lower power for battery-operated equipment higher switching frequencies for reduced magnetics size higher levels of circuit integration for improved reliability and lower cost. The UCC3802 family of devices is pin-out compatible with the UC3842 and UC3842A families; however it is not plu
• Descargar
  Conditioning a Switch-mode Power Supply Current Signal Using TI Op Amps
  PDF, 61 Kb, Archivo publicado: marzo 23, 2000
  The switch-mode power supply primary current is often sensed using a power resistor. Using an op amp to amplify the current-sense signal can reduce cost and improve noise performance and efficiency. This report reviews the advantages of using an op amp circuit and analyzes the design criteria needed to choose the proper op amp.
• Descargar
  Understanding Buck-Boost Power Stages in Switchmode Power Supplies (Rev. A)
  PDF, 363 Kb, Revisión: A, Archivo publicado: mayo 28, 2002

Linea modelo

Clasificación del fabricante

• Semiconductors > Power Management > Offline and Isolated DC/DC Controllers and Converters > PWM and Resonant Controller