Datasheet Analog Devices DAC08CS — Ficha de datos

8-Bit, High Speed, Multiplying D/A Converter
(Universal Digital Logic Interface)
DAC08
scale trimming in most applications. Direct interface to all
popular logic families with full noise immunity is provided by
the high swing, adjustable threshold logic input. FEATURES
Fast settling output current: 85 ns
Full-scale current prematched to ±1 LSB
Direct interface to TTL, CMOS, ECL, HTL, PMOS
Nonlinearity to 0.1% maximum over temperature range
High output impedance and compliance: −10 V to +18 V
Complementary current outputs
Wide range multiplying capability: 1 MHz bandwidth
Low FS current drift: ±10 ppm/°C
Wide power supply range: ±4.5 V to ±18 V
Low power consumption: 33 mW @ ±5 V
Low cost High voltage compliance complementary current outputs are
provided, increasing versatility and enabling differential
operation to effectively double the peak-to-peak output swing.
In many applications, the outputs can be directly converted to
voltage without the need for an external op amp. All DAC08
series models guarantee full 8-bit monotonicity, and nonlinearities as tight as ±0.1% over the entire operating temperature
range are available. Device performance is essentially unchanged …

REVISIONS
LTR DESCRIPTION DATE (YR-MO-DA) APPROVED A Changes in accordance with NOR 5962-R106-92. 92-01-09 M. A. FRYE B Add RHA requirements. Add device type 02. Add case outlines E and F.
Update boilerplate. – rrp 98-10-09 R. MONNIN C Make changes to 1.5, RHA designators in table I, and table IIA. – rrp 99-07-30 R. MONNIN D Make change to full range current test as specified in table I.
Add new footnote to 1.5 and table I. -ro 00-12-22 R. MONNIN E Make correction to the tPLH and tPHL tests conditions column as specified
under Table I. Make correction to figure 2. Delete 4.4.4.1.1, Accelerated aging
test. -ro 06-06-19 R. MONNIN F Make change to Nonlinearity max limit in table I for device type 02. Update to
latest Boilerplate. -jt 11-08-09 C. SAFFLE G Add device type 03 tested at low dose rate. Make change to paragraphs 1.2.2,
1.5, and 3.2.3. Make changes to footnotes 1/ and 2/ as specified under
Table I. Removed figure 2. Make change to Table IIB and
paragraph 4.4.4.1. -rrp 12-05-03 C. SAFFLE H Update drawing to current MIL-PRF-38535 requirements. –rrp 17-06-22 C. SAFFLE THE ORIGINAL FIRST SHEET OF THIS DRAWING HAS BEEN REPLACED.
REV
SHEET
REV
SHEET
REV STATUS REV H H H H H H H H H H H H OF SHEETS SHEET 1 2 3 4 5 6 7 8 9 10 11 12 PMIC N/A PREPARED BY
RICK C. OFFICER STANDARD
MICROCIRCUIT
DRAWING DLA LAND AND MARITIME
COLUMBUS, OHIO 43218-3990
http://www.landandmaritime.dla.mil CHECKED BY
CHARLES E. BESORE
APPROVED BY THIS DRAWING IS AVAILABLE
FOR USE BY ALL …